|
|
|
|
|
Press Brakes, Hydraulic Press Brake... |
  |
 |
 |
 |
 |
     |
 |
 Click
here for :
TECHNICAL
SPECIFICATIONS |
|
Salient Features :
|
|
| » The
stable robust, all welded steel frame from ultra sonically tested plates
are of top quality. Raw & table designed with special inclined member & box type structure for maximum strength. » The top beam is guided by three point roller with replaceable hardened liners for least wear. This eliminates lubrication of steel to provide better quality of cutting for alonger time. » Rake angle can be varied to permit shearing of higher thickness than nominal capacity & facilitating distortion free shearing of thin sheets. » The fastest & eagiest way of blade clearance setting without need of feeler gauge, which helps burr-free edges. » Positive holding by hydraulic holddowns before shearing avoids slippage of sheets & independent operation of holddowns for clamping of sheet helps checking of mark without taking shear stroke » Front gauging by dis appearing stoppers mounted on left squaring arm. Robust, heavy & accurate back gauging to set cutting width. » Hydraulic cylinder are designed with both low & high pressure sealing, hard chrome plated rod also with special type guide for long life without leakage. » Hydraulic components are of international quality standards & assembled on specially designed compact mambold block for easy maintance. |
|
Standard Accessories: |
|
|
» Main Drive Motor » Electric Control Panel » Operational Console » Pre selector switch to adjust rake angle » Lever operated blade clearance with calibration » Fine stroke adjustment rod with limit switch » Front sheet support » Squaring arm on right end with steel rule » Hardened transfer bar mounted on table » Hold down cylinders » Shadow light indicator » Four edge HCHCR / HCSR blade Interchangeable & suitable to shear mild and St. Steel » Manual back gauge |
|
Optional Accessories : |
||
|
» Motorised back gauge with DRO » NC back gauge with ball screw » Second squaring arm on left side » Front support with roller according to required length » Rear sheet support » Ball transfer table » Degree protector for angular cutting » Stroke counter » Design with throat depth » First fill of hydraulic oil |
 |
|
|
Click
here for :
TECHNICAL
SPECIFICATIONS |
|
Copyright © Santec Hydrofluid Engineers, All
Rights Reserved Site Developed by IndiaMART InterMESH Limited |
 |
